Forums Forums Enthusiast Forums A - Z Autowirral how do you get wording[sign] writeing of vechile

As above please or do you know any 1 that can do it thanks

Make sure you get it spell checked first.

Rake lane on junction with mount pleasent

do you mean taken off ?,thats how i read it .if so it should peel off ,you may have to lift it first with a sharp blade but after that depending on whats been used it should come of easily

I do vehicle signage matey. Small decals to full vehicle livery. Drop me a PM with what you want! Cheers Paul

DO NOT use a blade, use a heat gun and jobs a guddun

Agree with Ste, do not use a blade, you'll chip the paint.

Heat gun, or hair dryer, lifts them quite well,, although you will find it much easier in a warm garage or on a hot day (warms the metal on the car).

When you've taken them off it will likely leave a gluey residue, and the paint under the vinyl will be much brighter than the exposed paintwork. You can clear this up with a lot of elbow grease, or, what I did with one of mine after taking the vinyl off, was to drive it down to the American Car Wash and after two days and eighty notes it looked fantastic.

Thanks everyone much appreciated

If it's the plastic/metal words then a heatgun to melt the glue is the way to go. If it's a sticker, the same applies.

If, when you remove the wording, there is still adhesive residue left, simply spray a little WD40 onto it and rub it with a microfibre cloth. Removes glue like a treat.