Forums Forums Station : 1989 Toyota MR2

Looking good matey seen you the other day by the halfway house

I put the car on the bay of e, and was asked to take some photos of the rusty floors. I started to pick around with a screwdriver, and then got the drill with a end on it to get the sound deadening off for a better look, Before I knew it, I'd gone too far and ended up cutting out the bad bits with an angle grinder.
Not sure if it's worse than I expected, but it's never nice! I think the leaky t-bar roof's cause this much on the floor?
Driver's floor was welded up years ago, but was not rust proofed, so was rusted worse than the 20 year old rust. It was also welded over the old rusty metal. Totally pointless.

There's meant to be a rail running the full length under here, but it's gone - Toyota, why did you make this car so rust-prone?!?!


Driver's side is an "easy" job, there's a few patches on the back:



But passenger's is worse - all the corners are gone, under the seat rail, etc.



The front isn't too bad, the rail was totally intact. A few patches will get it through an MOT!



Hooray for my unbelievably crappy welding:

So, are you keeping it now you have done this work

As long as the welds are up to the job - its not like anyone is going to see it all under there

No, someone won on ebay and it's going to Plymouth on the weekend. There's no more rust and no holes. I'd deffo have another one of these but no more rust thanks.

fook!

Shame all that work and you're not keeping it

I'll be working away next month so I can't keep much anymore. I didn't really mention in the ad about massive holes in the floors, there's a couple of other things as well, it doesn't take too long and I quite like doing it. I did the other side today (got too dark to finish it properly), will hopefully do the little bits tommorow:

Car was picked up today and taken to Plymouth (!). Spent nearly a week getting it looking nice.