Latman needed - 25th Oct 2014 8:50am
Hi, I am adapting an electric motor to start my Lister CS generator. Does anyone have contact with someone who could do a little lathework for me?
I have a pulley which needs its centre turned out to around 72mm, also an aluminium bush to adapt from about 35mmID to about 12.5mm.
It's so I can fit a one way bearing between the motor and the engine. My Lathe is just too small.
Or perhaps someone with a lathe he want to swap for my model makers lathe???
Martin
I have a pulley which needs its centre turned out to around 72mm, also an aluminium bush to adapt from about 35mmID to about 12.5mm.
It's so I can fit a one way bearing between the motor and the engine. My Lathe is just too small.
Or perhaps someone with a lathe he want to swap for my model makers lathe???
Martin