Morning All,

I need some help with some wiring on my 2013 ford focus.

This may seem a little sad, but here goes!

I am looking at installing the boost gauges off a 2015 focus ST diesel to my 2013 tdci zetec.

It is just the wiring side that needs doing, apparently the gauges run off an electric system that runs on the can bus. So not even sure its possible to get it 100% working.

I cant get hold of ford wiring schematics so i wouldn't know.

But even if there was some kind of movement on the gauges or even worst case it lit up. Just rather than being completely redundant.

The gauges are installed and I have original plug which has 5 wires coming off it.

I would chance it myself my hooking the illumination wire to a live feed and earth to the vehicle but chances are i would blow the car up!

If anyone is confident and fancies it, or knows someone let me know please, I have cash waiting for the job to be done!

Thanks

There's an indy Ford place down by Screwfix near Lairds, I'd probably go there if it were me.

Thanks Gibbo!

I will see if I can find some details and give them a call, if not I will pop down when i can.

Much appreciated