My laddo has treated himself to a rather large 139cm x55 and heavy flat screen and wants it hanging from wall on a bracket. Not read the bumpf yet but assuming it can be wall mounted any tips on fixing to drylining ( i think). Its the old rendered outside wall of the house that had an extension added. Possibly a timber frame fixed to wall first but have no plans to verify. Got a cable pipe detector to give some clues. Maybe i can convince him just to get a unit to stand it on. Hitting youtube for some ideas but any info appreciated. cheers
A stud detector (really a nail detector) will tell you if there are studs. If the bracket can't screw into two of them its best to put a batton across studs and fix it to that. Sometimes a sheet of plywood can look better, because its wider it doesn't have to be so deep.
Dry wall would take the weight with the proper dry-wall fixings but I never like risking it.
If its a stud-less dry-lining (eg glued to wall which less likely if its an outside wall) I'd be tempted to use a proper wall-bolt or frame bolt type thing into the brick
We don't do charity in Germany, we pay taxes. Charity is a failure of governments' responsibilities - Henning Wehn
I'd check to find the spacing of the studs and look for a bracket that matches it. You may be lucky, otherwise you'll have to follow DD's advice.
I was lucky, having a layer of plaster on a brick wall, and used wall bolts. This was necessary for the original flat screen telly we had, but a more recent one is bigger, but a lot lighter.
I would not trust drywall. I've hung a 46in Samsung onto a single stud with a swinging/tilting bracket. The bracket has a plate (approx 6 x 2 inches) screwed with 6 big screws into the stud. I drilled tiny holes into the drywall to confirm the exact position of the stud and filled them with a bit of filler once the bracket was positioned. It's been up four years and I've changed the TV on it once. Screws are angled slightly towards the centreline of the stud.
Being a joiner for 40 years i do enjoyed these posts, there has yet to a stud wall built in a new house that will take the direct load of a Tv yet it does.
Most stud walls are floating ie not attached to the outer skin of the house in the past i have seen whole walls collapse some new stud is only 60mm x 42mm old stud is 75mm x 50 with the random firing of nail guns which due to speed and price work hit and miss, the stud is held in place by the plasterboard.
The best method on stud is an 18mm ply pre drill holes 60mm x 5 screws then use screws provided to secure bracket to ply that covers you for insurance / claims etc.
Never attempt to fit to a drylined wall unless its concrete solids, thermolites are a disaster waiting to happen there is not a fitting yet invented to take the load.
....some new stud is only 60mm x 42mm old stud is 75mm x 50 ......
I've recently dry-walled a room and ceiling with the small studding and was feeling very guilty at the time, I not sure it paid off in cost, time or effort. Smallish room, awkward to work in, needed a semi-permeable membrane and I didn't want to reduce the size of the room. I wasn't convinced I could nail plasterboard that close to the edge so had to double up the noggins and some of the studs.
We don't do charity in Germany, we pay taxes. Charity is a failure of governments' responsibilities - Henning Wehn