I HAVNT GOT A OIL LIGHT ON THE CAR WHEN I START IT UP (WHEN IT COULD START).

Have had the bigend shells done but carnt turn the crank over so going to get it done again but noticed i had no light if its not a buld (which i dont think is) what is it and should i worry??

ITS ON THE 4I WHICH IS A 2.8 V6 ENGINE.

Probably the wire come off the oil pressure sensor mate.

It gets earthed through the switch when the ignition is switched on therefore illuminates the lamp. If the wire has come off the lamp wont illuminate.

Simply locate the oil pressure sensor on the side of the main engine block and check if the wire is still on ?

If it is you may have trapped it under the cradle when refitting it.

The sensor looks like this but may have a threaded connector on it ?

[img]http://img.ebigchina.com/cdimg/175745/579732/0/1072702207.[/img]

Tupac am virtually sure it hasnt been connected from when I left it. Dont worry

ok cheers guys.