Custom exhaust adapting/fitting - 11th Jul 2006 7:10pm
Took my old exhaust of the green car recently as ive decided it'd look good as a single exit system on my Si,and my little bro can put the other exit on his 1.4 mk6 scort
Questions i have are
Can a 2" bore pipe into the silencer be welded up to/clamped to,lengthened and bended to meet the back of the mid section on my brothers car (he will only be using 1 backbox including the 6x4 oval-2 1/2" short pipe-back box-2" bore mid secion connecting pipe)
I however am using the 2" mid section,from the cat,with no silencer,to where it connected to the Y pipe and i want to mate it up to the 2" pipe that enters the backbox,which then exits the backbox as a 2 1/2" pipe which then welds to the 6x4 oval. This will need the gap filling with 2" bore pipe bended and welded/clamped to fit
And if i wanted to quieten down my system,would welding a 3" bore 10 inch long pipe in the middle of the mid secion (so it gets wider for 10 inches then narrower again) will that silence it a bit?
and who could do these jobs and how much would they cost?
Ideally need a reply from Cybox (sprayforce) staff here
Questions i have are
Can a 2" bore pipe into the silencer be welded up to/clamped to,lengthened and bended to meet the back of the mid section on my brothers car (he will only be using 1 backbox including the 6x4 oval-2 1/2" short pipe-back box-2" bore mid secion connecting pipe)
I however am using the 2" mid section,from the cat,with no silencer,to where it connected to the Y pipe and i want to mate it up to the 2" pipe that enters the backbox,which then exits the backbox as a 2 1/2" pipe which then welds to the 6x4 oval. This will need the gap filling with 2" bore pipe bended and welded/clamped to fit
And if i wanted to quieten down my system,would welding a 3" bore 10 inch long pipe in the middle of the mid secion (so it gets wider for 10 inches then narrower again) will that silence it a bit?
and who could do these jobs and how much would they cost?
Ideally need a reply from Cybox (sprayforce) staff here