i have just installed my new amp and sub and was wondering if you no if you can put a switch half down on the remote wire so that you can turn your amp on and off via the switch. has anyone tried this before or does anyone no if this is possible. i want to do this so that when i dont have the music on loud, my amp wont drain my battery. many thanks
you can, i ve just done it and its a very interesting thing to have and use
is ti easy to do and where did u get ur switch from? pictures would be helpful. cheers
just any switch, as long as its a 12 volt one and has at least 2 pins on the back
motorworld do nice silver flick switches
just cut the remote wire in two and connect either side of the switch
job done
5 min job at the most
thanks for the advice. going to get one later from motorworld
just fitted it. only cost me £1.99. exactly what i wanted,thanks for the advice everyone
how long it take you in the end???
it took me about ten seconds. all i did was cut the wire and then striped the wire at each end and then reconected the wire on the switch. simple
told you, good little mod as well
its a really cheap mod that comes in very handy.specially if you have a headache and youve got a jbl 15 inch sub and a 1000 watt amp like me. the bass can sometimes be to much