Forums Forums Enthusiast Forums A - Z Autowirral Dazza: Fiesta SI

That would make it look allot better matey, smoked i recon

Been ages since this was updated and not alot has happend really guys. Iv just stuck it in my garage so now work can commence and i'll keep you all updated, for now tho am after a few bits so am scouring the land

Need to sort the Air-intake for the fezz if its going 2.0 so i came across a good idea,

Before


Midpoint, trial fitment before spray


Done but may give it a few more layers

yeah ive seen that on a few cars and it looks different and has a purpose aswel. also completely legal (i think) as the inside lights are only 'driving lights' the outside ones are the main/dipped etc

There not used on my morrettes at all, both headlight and sidelight are included in the same lens (The outside one). The inside is mearly for looks

not red mate, maybe chrome?

READ meesh, he's spraying it

Should be good mate, look forward to seeing it done.

Picture updated of Morrettes if u scroll up

mmmmm Going to look sweet.

Wounder were your getting the 2ltr from.

Tell us some details on the 2.0 mate.

What is it from
What sort of adaptation do you need to do to engine bay/loom

Gonna be one rapid motor when its in. Think u shud get at least 150BHP from it then go and show ford ST dept how to do it properly

Not going to say too much incase some of the plans dont go about. Its a 2.0 silvertop (found in early Mondeos) and is basicly the engine that was in my Escort.

The difference now is I can use 2.0 parts/management seeing his Fiesta and Mondeo share the same PATs (I know it can be done on Escorts but as far as I know only 2 people have done it).

Am going to experiance Torquesteer aparantly and seeing as I need new wishbones am opting for New Ford wishbones with a camber adjuster (Courtesy of Area 6 aka Fiesta Frenzy)

The engine is 136BHP at standard, am getting reprofiled cams to KentCams spec which will give an estitmated extra 12BHP but with more livley throttle responce and high revs.

Am not going to give you all my shopping list as money is tight at times like this but ill currently be running the IB5 gearbox but may upgrade to the MTX75 at a later date once all is running well.

On top of that iv bought some 4WD Cosworth calipers (Need pads and discs now) oh and a charge carrier.

Watch this space

Sounds good to me i cnt wait for the finish job.

These arrived on wednesday morning. Gonna clean them up and flick a bit of blue paint on them


There Sierra Cosworth 4WD calipers

The build starts!
Here is a pic as it stood today


Then after this pic I took the front end off ready for after my holiday, then I can start the madness!
------------------------------------------
Admin Edit : Resized & hosted pics

and just think that car used to be like this:



:go: